209 Rockwell Automation Publication 2097-UM001D-EN-P - November 2012
Appendix C Kinetix 300 Drive ID Tag Numbers
672 REAL
R/W Current output clamp. Range: 0…400% X
676
REAL
R/W
User units scaling. Range: 1…1000000
X
678
DINT R/W
Measure units.
0 = μm
1 = m
2 = in.
X
(1) The hardware overtravel configuration in the MotionView OnBoard software has been enhanced to allow the configuration of the inputs as normally open or normally closed when this firmware is used on hardware revision 1B. The hardware revision can be found by
reading the last four digits of the Type field on the carton label.
Table 78 - Kinetix 300 Drive Tag Numbers (continued)
ID
Data
Type
Access Description Value/Notes
MotionView Page Used
Top Level
Motor-Synchronous
Motor-Linear
General -Synchronous
General -Linear
EtherNet
EtherNet/IP (CIP)
Digital I/O
Analog I/O
Velocity Limits
Position Limits
Dynamics
Indexing
Homing
Monitor
Faults
To Next Page
Loading...
