Allen-Bradley PowerFlex400 User Manual

Index-2
H
Heatsink OvrTmp Fault, 4-3
HW OverCurrent Fault, 4-3
I
I/O
Wiring, 1-15
Wiring Examples, 1-20, 1-23
I/O Board Fail Fault, 4-5
Input Contactor, 1-15
Input Fusing, 1-9
Input Power Conditioning, 1-7
Installation, 1-1
Integral Keypad, 2-3
Interference, EMC/RFI, 1-27, 1-29
K
Keypad, 2-3
L
LEDs, 2-3, 2-4, 2-6, 2-7, 2-8, 2-9
M
Metasys N2
point map, F-3, G-2
Minimum Clearances, 1-4
Motor Cable Length, 1-13
Motor Overload, 4-3
Motor Overload Fault, 4-3
Motor Stalled Fault, 4-3
motor starter, 1-9
Mounting Options and Clearances,
1-4
MOVs, 1-6
O
Opening the Cover, 1-1
Operator Interface, 2-3
OverVoltage Fault, 4-3
P
Parameter
Descriptions, 3-1
Ty p e s , 3-1
Viewing and Editing, 2-5
Parameter Checksum Fault, 4-4
Parameters
Display Group, 3-4
Program Group, 3-7
PE Ground, 1-8
Phase Short Fault, 4-4
Phase to Ground Fault, 4-4
point map
Metasys N2, F-3, G-2
Power Cables/Wiring, 1-11
Power Conditioning, Input, 1-7
Power Connections, Single-Phase,
A-7
Power Loss Fault, 4-3
Power Unit Fault, 4-4
Powering Up the Drive, 2-1, 2-2
Precautions, General, P-3
Product Selection, B-1
Program Group Parameters, 3-7
Programming, 3-1
R
Ratings, A-1
Reflective Wave Protection, 1-13
Removing Cover, 1-1
Repeated Start/Stop, 1-15
Repeated Start/Stop Precautions,
1-15
RFI, see EMC/RFI
RWR (Reflective Wave Reducer),
1-13
S
Safety Ground, 1-8
Shielded Power Cables, 1-11
Short Circuit Protection, 1-9
Single-Phase Input Power
Connections, A-7
Software, 3-1
Start and Speed Reference Selection
and Control, 1-24, 1-25
Start/Stop, Repeated, 1-15
Start-Up Checklist, 2-1, 2-2
Static Discharge, ESD, P-3
Status LEDs, 2-3, 2-4, 2-6, 2-7, 2-8,
2-9
Supply Source, AC, 1-6

Allen-Bradley PowerFlex400 Specifications

General

Brand	Allen-Bradley
Model	PowerFlex400
Category	Controller
Language	English