Amada LW500A - Correct Password; Incorrect Password; Password-Protected Settings and Functions

CHAPTER 3: PROGRAMMING FUNCTIONS
LW500A/LW600A PULSED Nd:YAG LASER
990-539 3-17
Incorrect Password
If an incorrect password is entered, the message window
shown on the right will appear. Press the OK button to return
to the PASSWORD screen.
Correct Password
Once a new password has been entered, a
confirmation screen will appear. Re-enter the
same password.
If the passwords match, then the new Password
will be set. If they don’t match you will get a
“Wrong Password” message.
Password-Protected Settings & Functions
SCHEDULE number SHOT (Seam setting)
FORM (FIX / FLEX) Setting POWER (Seam setting)
PEAK POWER Setting POSITION BLINK (Guide Beam)
REPEAT (pps setting) FIBER TYPE (SI/GI)
↑SLOPE (Fix setting) FIBER SIZE (Diameter)
FLASH1 (Fix setting)
RESET COUNT
COOL1 (Fix setting) SHOT Count
FLASH2 (Fix setting) GOOD Count
COOL2 (Fix setting) PRESET Count
FLASH3 (Fix setting) HIGH (Upper Laser Energy Limit)
↓SLOPE (Fix setting) LOW (Lower Laser Energy Limit)
POINT 01 – 20 (Flex settings)
REFERENCE SETTING