Putting to operation
114
Cirrus 3/4/6000 DB2034 08.04
7.12 Turning at the headlands
Before turning at the headlands
- slow down the speed
- do not reduce the tractor's rev. speed too much to
ensure that the hydraulic functions will react prop-
erly at the headlands.
- actuate control unit 2
- as soon as the machine is lifted, turn (if desired
until full lock of the tractor steering).
Fig. 184
Hint!
When actuating the control unit 2
- the machine is lifted with the aid of the integrated running gear.
- the lifting of the coulter frame is locked with the Low-Lift function switched on.
Only activate the Low-Lift function when it is ensured that the coulters will not touch
the ground when turning.
- the star wheel is lifted and the tramline control shifts on.
- the track markers are folded in.
After turning
- actuate control unit 2 and
- start driving in the field.
Hint!
When actuating control unit 2
- the machine and the coulter frame are lowered
- the opposite track marker is lowered into work
- the star wheel is set into operational position
depending on the pre-selection in .
To Next Page
Loading...
Need help?
General
