EasyManuals Logo

Amazone Cirrus 3000 User Manual

Amazone Cirrus 3000
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
Settings
60
Cirrus 3/4/6000 DB2034 08.04
5.3.1 Proportional seed rate change during operation
Proportional seed rate change during operation:
- Page 1 (Fig. 89)open in the menu machine data.
- Input of quantity step as % (value for the
proportional seed rate change during operation with
, ).
- By pressing key reset the seed rate change
back to 100%.
Fig. 89
5.4 Calibration test
With the calibration test the coincidence of the pre-set and the actual seed rate is
checked.
Always carry out a calibration test
when changing the seed type
in cases with the same seed type, however, with different grain shape, grain size,
bulk density and or different dressing
after having changed the metering wheels
in cases of a deviation between the seed rate determined by
and the quantity of seed applied in the field.
Caution
Before commencing the calibration test
Stop tractor engine
Remove ignition key
5.4.1 Calibration test on Cirrus with Vario gearbox with seed rate remote control
Calibration test on the Cirrus with Vario gearbox with
seed rate remote control:
- Fill the seed hopper up to min. 1/3 of its volume with
seed (correspondingly less for fine seeds at fine
seeds.
- Take the seed collecting trays off the transport
retainer on the rear side of the hopper.
For transport the seed collecting trays are fitted into
each other and secured with a lynch pin (Fig. 90/1)
on the rear side of the seed hopper.
Fig. 90

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Amazone Cirrus 3000 and is the answer not in the manual?

Amazone Cirrus 3000 Specifications

General IconGeneral
BrandAmazone
ModelCirrus 3000
CategoryFarm Equipment
LanguageEnglish

Related product manuals