General safety advice
16
Cirrus 3/4/6000 DB2034 08.04
2.12 Constructional changes
Vehicles and devices and implements, connected with a vehicle with an official
operating permit for road traffic according to the traffic law should correspond to the
condition as stipulated by the relevant permit 29 § 4).
2.12.1 Alterations or changes
Never carry out any alterations or fittings or changes on the machine without approval
of the . This also applies for welding work on
bearing parts.
All fitting or alteration measures require the written approval of
. Only use the conversion and optional parts
approved by Messrs. so that the operating permit
remains valid according to national and international regulations.
Important!
Prohibited on principle is
•
re-boring existing holes on the frame or the chassis
• re-boring existing holes on the frame or the chassis
• welding on bearing parts.
2.13 Spare parts and wearing parts and auxiliary parts
Immediately exchange defective machine parts.
Only use original- -spare- and wearing parts or the parts approved
by Messrs. so that the operating permit remains
valid according to the national and international regulations. When using spare and
wearing parts from other manufacturers it is not ensured that they have been
designed and manufactured to fulfil the operational stress and safety demands.
The do not accept any liability for damage by
using not approved spare or wearing parts or auxiliary parts.
2.14 Cleaning and disposal
Utilise agents and materials and dispose them in the appropriate manner particularly
•
when working with greasing systems and devices
•
when cleaning with solvent agents.
2.15 Workplace of the operator
The machine may only be operated by one single person from the seat in the tractor
cab.