Putting to operation
Cirrus 3/4/6000 DB2034 08.04
93
7. Putting to operation
7.1 Coupling and uncoupling the machine
The Cirrus is not provided with a parking brake.
Before uncoupling, always secure the Cirrus by
applying 4 chocks (Fig. 136), each 2 chocks on both
machine sides underneath the outer wheels of the
wedge ring roller.
The Cirrus can be coupled or uncoupled when folded
in or out (except for Cirrus 3000). In both cases the
Cirrus rests on all tyres of the wedge ring roller.
Fig. 136
Danger!
When uncoupled from the tractor always secure the Cirrus with 4 chocks (Fig.
136) as the Cirrus is not provided with a parking brake.
Important!
When coupling vehicles always use the intended devices in the appropriate way.
Danger!
Allow nobody to stand between tractor and implement while the tractor backs up
for coupling or uncoupling the machine.
Any assistants may only act as lookout at the side of tractor and machine.
The lower link arms of the tractor should not have any lateral play so that the
machine centrally follows the tractor and does not swing.
Observe chapter 2.19.4 (towed implements)!
Caution!
Only create machine connections when tractor and machine are coupled, with
the tractor engine switched off, the parking brake applied and the ignition key
removed.
Only couple the supply hose (red) of the brake on to the tractor when the tractor
engine has been switched off, the parking brake has been applied and the
ignition key has been removed.
To Next Page
Loading...
Need help?
General
