General safety advice
24
Cirrus 3/4/6000 DB2034 08.04
2.19.3 Operation – seed drills
• During the calibration test mind danger zones with rotating and oscillating
implement parts.
• Use the platform only for filling.
During use riding on the platform is not permissible!
• For road transport remove the marker discs of the tramline marker.
• When filling the seed box observe the advice of the implement manufacturer.
• Lock track markers in the transport position.
• Never place any parts into the seed box.
• Observe the permissible filling amount.
2.19.4 Towed implements
• When fitting carefully observe that the mounting categories of tractor and
implement coincide or that they are matched.
• Adhere to the manufacturer's advice!
• In the area of the tractor locker link arms there is danger of injury by its
crushing and shearing areas.
• The exterior actuation of the tractor lower link arms is forbidden. Actuate the
tractor lower link arms only from the tractor cab.
• Hitch the machine as prescribed. Check the function of the hitching brake
system. Observe the manufacturer's prescriptions.
• The implement may only be trailed by a suitable tractor.
• There is danger of injury when mounting implements!
• Never allow anyone to stay between tractor and implement without having
secured by chocks against rolling away!
• When operating the supporting devices danger by crushing or shearing may
occur!
• When mounting of machines at the front and/or in the rear do not exceed
- the permissible tractor total weight.
- the permissible tractor axle loads.
- the permissible tyre carrying capacity of the tractor tyres.
• Observe the maximum payload of the mounted implement and the permissible
axle loads of the tractor!
• Before starting to travel with the machine always ensure sufficient lateral
locking of the tractor lower link arms.
• Before travelling on public roads secure the control lever for the tractor lower
link arms against unintended lowering.
• For travelling on public roads bring all devices into transport position!
• Mounted implements and ballast weights affect the driving behaviour as well as
steering and braking of the tractor!
• The tractor front axle load must be at least 20 % of the tractor's net weight in
order to ensure a sufficient steering. If necessary use front weights!
• As a matter of principle always remove ignition key before conducting any
repair, maintenance and cleaning operation!
• Keep all guards fitted and always in serviceable condition!
To Next Page
Loading...
Need help?
General
