Maintenance, repair and care work
152
Cirrus 3/4/6000 DB2034 08.04
10.7 Setting the tramline to another bout width (workshop job)
When purchasing the machine and the husbandry
tractor, check whether the tramline setting in the
distributor head corresponds to the track width of the
husbandry tractor.
The tramline control properly corresponds to the track
width of the husbandry tractor when the following
points have been observed:
• The seed tubes (Fig. 245/1) of the tramline
coulters must be affixed to the distributor head
openings which can be closed by the shutters (Fig.
245/2).
If necessary exchange the seed tube among each
other.
• The track width changes with the number of
coulters which do not sow seed when creating
tramlines.
When creating two tracks the shutters (Fig. 245/2)
in the distributor head can close per track
• on Cirrus 3000/4000 up to 3 openings
• on Cirrus 6000 up to 6 openings.
• Deactivate not needed shutters (Fig. 245/2), as
described in chapter 10.7.1.
Fig. 245
Important
Adjust the marker discs of the pre emergence marker (if existing) to the new
track width according to chapter 5.11.1!
10.7.1 Activate or deactivate the shutters (workshop job)
Before fitting stop the tractor engine, remove ignition
key and switch off the .
To activate or deactivate the shutters, remove the
following parts on the distributor head:
- Distributor outer hood (Fig. 246/1)
- Ring (Fig. 246/2)
- Distributor inner hood (Fig. 246/3) and
- Foam rubber insert (Fig. 246/4).
Fig. 246
To Next Page
Loading...
Need help?
General
