User manual Introduction
1.5.4 Radio modem for the communication between track trolley and total
station
Radio modem model Remarks
Leica TCPS26
Leica TCPS27
Leica TCPS28
Leica TCPS29
Leica TCPS30
Leica radio handle RH1200, RH15, RH16,
RH17
■
You either need a pair of radio modems or
a radio handle with one radio modem.
■
Please ensure that you have a compatible
pair of radio modems (respectively a
radio modem with the corresponding radio
handle for the total station). Please contact
Leica Geosystems for support for the
configuration of the radio modem.
■
Please read the corresponding product
documentation and user manual.
1.6 Trademarks
“Windows”, “Windows XP”, “Windows 7” and “Windows 10” are registered trademarks of the
Microsoft Corporation.
All products and company names referred to in this documentation are the property of their
respective trademark holders.
1.7 Available documentation
The following manuals for the other components of the GRP System FX are available:
■
Amberg Rail 3.0: Measurement and evaluation software for GRP 1000, GRP 3000, GRP
5000, VMS 1000, VMS 3000, IMS 1000, IMS 3000 and IMS 5000
■
Leica TPS Total Station (see Section 1.5.1, “Total station for georeferencing of GRP System
FX” on page 15. for list of supported total stations)
■
Leica GNSS Global Positioning System (see Section 1.5.2, “GNSS system for
georeferencing of GRP System FX” on page 16. for list of supported GNSS)
■
High-speed laser scanner (see Section 1.5.3, “High-speed laser scanner for the configuration
GRP/IMS 5000” on page 16 for list of supported laser scanners)
■
Battery chargers
■
Control computer Panasonic CF-19/20
■
Leica radio modem / radio handle
Please read all manuals carefully before using the system. Please contact Amberg
Technologies or your local dealer if you require any other manuals.
An overview of components and accessories is given in Section 1.9, “System
components” on page 19
1.8 Principle of measurement and terminology
The railway surveying system GRP System FX can be used in different configurations
according to requirements. The following explanations show some of the fundamental
differences:
© Amberg Technologies AG, 2023 Page 17 of 114
To Next Page
Loading...