Amberg Technologies GRP System FX - Connection Schemes; GRP Relative; GRP 1000

To Next Page

To Previous Page

User manual Assembly, Installation, Start Up

The battery GEB 5000 / GEB 5010 can be

exchanged without the entire system being

completely disassembled.

Proceed as follows:

■

Switch off the power at the main switch (1).

■

Disconnect the power cable from the

scanner.

■

Disconnect cable (2) from the TGS FX.

■

Release the bolts (3).

■

Remove the battery GEB 5000 / GEB 5010

by tipping it forward.(4)

■

Follow the procedure in reverse for the

reassembly.

Please see Section 5.10, “Battery charging” on page 78 for information about charging the

battery module GEB 5000 / GEB 5010.

4.9 Connection schemes

Following sketches show the cabling with different configurations.

4.9.1 GRP Relative / GRP 1000