Safety Directions User manual
Precautions: Use only the equipment and accessories recommended by Amberg
Technologies. When combined with the product, they meet the strict requirements
stipulated by the guidelines and standards. Pay attention to the information about
electromagnetic compatibility provided by the manufacturer when using computers and
two-way radios.
Disturbances caused by electromagnetic radiation can result in erroneous
measurements. Although the product meets the strict regulations and standards which
are in force in this respect, Amberg Technologies cannot completely exclude the
possibility that the product may be disturbed by very intense electromagnetic radiation,
for example, near radio transmitters, two-way radios or diesel generators.
Precautions: Check the plausibility of results obtained under these conditions.
If the product is operated with connecting cables attached at only one of their two
ends, for example external supply cables or interface cables, the permitted level
of electromagnetic radiation may be exceeded and the correct functioning of other
products may be impaired.
Precautions: While the product is in use, all connecting cables must be connected at
both ends.
Do not use cellular phones in the proximity of the trolley while executing measurements.
Even if GRP System FX meets EMC standards one cannot completely exclude the
possibility that the product may be disturbed by cellular radiation.
Precautions: Use cellular phone from a distant location away from the GRP System FX.
3.9 FCC Statement (applicable in U.S.)
The framed paragraph below is only applicable for products of the GRP System FX without
radio, digital cellular phone devices or Bluetooth.
This equipment has been tested in all possible configurations and found to comply with
the limits as listed below:
Class A digital device, pursuant to part 15 of the FCC rules.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and the receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
The following message is located on the labels of the system:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
Page 38 of 114 © Amberg Technologies AG, 2023
To Next Page
Loading...