User manual Maintenance, checking and adjustment
The odometer sensor is checked and adjusted before shipment.
During normal use, the odometer should not require frequent adjustment.
Wear of the odometer wheel or some conditions of the railhead surface may cause inaccurate
measurements.
For further details see the Amberg Fidelity help.
6.7 Check and adjustment of the automatic tribrach GAD
12
Table 1.
The level can be set with the adjusting
screws located behind a cover screw at the
side of the automatic tribrach GAD 12.
We recommend installing a total station and
using the level indicator of the total station to
adjust the zero positioning of the automatic
tribrach GAD 12.
© Amberg Technologies AG, 2023 Page 81 of 114
To Next Page
Loading...