7-16
P129390-106 Operator Manual Cycle and Control Value Programming
The setting on this screen is either Manual or Automatic. If the utility
control button displays Manual (and Automatic operation is
preferred), press the utility control button to change setting to
Automatic. If Automatic is displayed on the button (and Manual
operation is preferred), press the button to change to Manual.
Once the preferred operating mode is displayed (i.e., Manual or
Automatic), press Exit button to return to the setup machine screen.
If restart and shutdown times must be set, press the Next button to
advance to a screen where automatic utility restart and shutdown
times can be set up.
Using automatic utility control, the sterilizer can be set to control the
following:
• Daily restart time
• Daily shutdown time
NOTE: Restart and shutdown times are set up separately for each
day of the week.
To Next Page
Loading...
