7-19
Cycle and Control Value Programming Operator Manual P129390-106
8. If an incorrect value is entered, press the backspace key to clear
the entry, then use the keypad to enter the correct value.
9. Press Exit to abandon changes and return to the Machine Setup
screen.
OR
Press OK to save utilities set up changes and return to Utility
Control screen.
Important: If the sterilizer is processing a cycle when a preset utility
shutdown time arrives, the cycle completes before the sterilizer shuts
itself off. The sterilizer can be manually restarted and will remain on
until the end of the next cycle.
To Next Page
Loading...
