The easiest way to select the signal type for a plug is to auto-detect the signal type on the sources connected
to the plug. If the auto-detected signal type does not seem right, you can always force the signal type to use
on the plug.
To auto-detect the signal type on a plug:
NOTE:
• If displayed, the input may flicker.
• The input plug may change temporarily.
Front Panel
1. Enter the INPUTS menu on the Front Panel interface.
2. Scroll down and select an input to access the selected input setup menu.
TIP: Double-click on an INPUT SELECTION button to shortcut to the input setup menu directly.
3. Select Plug Settings to access the plug settings menu for the selected input.
4. Select Autoset to start the signal auto-detection process:
• Select YES to confirm.
• Select NO to cancel the action.
To Next Page
Loading...
Need help?
General
