The setup area of this screen contains the following groupings of parameters,
placed on separate tab pages:
General setup parameters
Master clock specific parameters
Timing-specific parameters
Advanced parameters
Profile option parameters
Setup tabSetup tab
The SetupSetup tab contains the general setup parameters for IEEE 1588v2.
Transport protocolTransport protocol
Touching the protocol button will launch the detailed mode dialog box (the
IEEE 1588v2 Protocol dialog box). Touching the arrow to the right of the
button ( ) will open the quick selection menu. You can set up the transport
protocol(s) for PTP messages either by selecting one of the predefined
configurations (e.g. ETH/VLAN/IPv4/UDPETH/VLAN/IPv4/UDP) from the quick selection menu or
by configuring the protocols via the detailed mode dialog box.
Depending on the transport protocol setting, Profile setting will be forced to
User DefinedUser Defined.
ProfileProfile
Select the profile of PTP (Precision Time Protocol) from below.
User DefinedUser Defined: Allows you to define the PTP profile. Available IEEE 1588v2
domain is 0 to 255. Unicast/Multicast and the delay mechanism can be set.
G.8265.1G.8265.1: Uses the PTP profile defined in ITU-T G.8265.1. This profile is used
for unicast mode. Available IEEE 1588v2 domain is 4 to 23. Transport protocol
will be set to ETH/IPV4/UDPETH/IPV4/UDP.
G.8275.1G.8275.1: Uses the PTP profile defined in ITU-T G.8275.1. This profile is used
for multicast mode. Available IEEE 1588v2 domain is 24 to 43. Transport
protocol will be set to ETHETH.
G.8275.2G.8275.2: Uses the PTP profile defined in ITU-T G.8275.2. In this profile,
UnicastUnicast and Unicast negotiationUnicast negotiation check boxes are both selected. Available
To Next Page
Loading...
