Anritsu MT1810A - Page 201

7.4 Automatic Measurement Commands
7-83
7
Remote Commands
:DISPlay:RESult:EDIagram:TEMPlate:PLOT <phase>,<voltage>
Parameter <phase>=<DECIMAL NUMERIC PROGRAM DATA>
–1000 to 1000 –1000 to 1000 mUI/1 mUI Step
<voltage>=<DECIMAL NUMERIC PROGRAM DATA>
–4000 to 4000 –4000 to 4000 mV/1 mV Step
Function Sets a Mask point position.
Example To set a Mask point position to 1000 mUI (phase), 4000 mV (voltage):
> :DISPlay:RESult:EDIagram:TEMPlate:PLOT 1000,4000
Compatibility Incompatible with existing models.
:DISPlay:RESult:EDIagram:TEMPlate:DELete <pos>
Parameter <pos>=<DECIMAL NUMERIC PROGRAM DATA>
1 to 32 1 to 32 points, in 1-point steps
Function Deletes the selected Mask point.
Example To delete Mask point 3:
> :DISPlay:RESult:EDIagram:TEMPlate:DELete 3
Compatibility Incompatible with existing models.
:DISPlay:RESult:EDIagram:TEMPlate:CLEar
Function Clears the selected Mask pattern.
Example > :DISPlay:RESult:EDIagram:TEMPlate:CLEar
Compatibility Incompatible with existing models.
:DISPlay:RESult:EDIagram:TEMPlate:VERTical
Function Plots a Mask pattern onto the vertically-symmetric position.
Example > :DISPlay:RESult:EDIagram:TEMPlate:VERTical
Compatibility Incompatible with existing models.
:DISPlay:RESult:EDIagram:TEMPlate:HORizontal
Function Plots a Mask pattern onto the horizontally-symmetric position.
Example > :DISPlay:RESult:EDIagram:TEMPlate:HORizontal
Compatibility Incompatible with existing models.