Anritsu MT1810A - Page 206

Chapter 7 Remote Commands
7-88
Table 7.4.4.1-1 Measurement Setting Commands (Cont’d)
No. Item Command
[10] Lower Error Threshold :SENSe:MEASure:BATHtub:RANGe
:SENSe:MEASure:BATHtub:RANGe?
[11] Calculation Error Threshold :SENSe:MEASure:BATHtub:CALRange
:SENSe:MEASure:BATHtub:CALRange?
[12] Auto Search :SENSe:MEASure:BATHtub:ASEarch
:SENSe:MEASure:BATHtub:ASEarch?
[13] Current :SENSe:MEASure:BATHtub:CURRent
:SENSe:MEASure:BATHtub:CURRent?
[14] Jitter Calculation Setting :SENSe:MEASure:BATHtub:JCALculation
:SENSe:MEASure:BATHtub:JCALculation?
[15] J2 Measurement :SENSe:MEASure:BATHtub:J2Meas
:SENSe:MEASure:BATHtub:J2Meas?
[16] Selection of Slot(s) to be
measured
:SENSe:MEASure:BATHtub:SELSlot
:SENSe:MEASure:BATHtub:SELSlot?
[17] Selection of Slot(s) you want
to view measurement results
:SENSe:MEASure:BATHtub:DISPlay
[18] Set All :SENSe:MEASure:BATHtub:SLASet
[19] Reset All :SENSe:MEASure:BATHtub:SLAReset
[20] MU181500B Reference Clock
Input
:SENSe:MEASure:BATHtub:REFClock
:SENSe:MEASure:BATHtub:REFClock?
[21] Operation Bitrate :SENSe:MEASure:BATHtub:OPERation
:SENSe:MEASure:BATHtub: OPERation?
:SENSe:MEASure:BATHtub:STARt
Function Starts Bathtub measurement.
Example > :SENSe:MEASure:BATHtub:STARt
Compatibility Incompatible with existing models.
:SENSe:MEASure:BATHtub:STOP
Function Stops Bathtub measurement.
Example > :SENSe:MEASure:BATHtub:STOP
Compatibility Incompatible with existing models.