(2) Connecting to control PC:
Connect the USB connector (type A) to PC, and then connect the
USB connector (type B) to the MP1862A.
Figure 2.1.4-3 Connecting to Control PC
Note the following when connecting two MP186xAs to control PC:
•
For PC with multiple USB connectors, connect to the USB
connector with the same USB controller, as shown below.
It may not function normally if connecting to the connector with
different USB controller.
•
If the number of USB connectors on the Control PC is not
enough, use a USB hub.
Note
Anritsu is not responsible for the proper functioning of all USB
hubs.
Control PC with MX180000A
To Next Page
Loading...
