Anritsu MX269018A - Digital Code Squelch Data Setting

3.8 Digital Code Squelch Data Setting
3-81
3
Measurement
[5] Code select mode
Selects how to set DCS Code.
When editing the code by rotary knob,
Standard 83: Only the codes defined in Standard 83 are
displayed.
Standard 104: Only the codes defined in Standard 104 are
displayed.
All codes: The code can be edited in increments or decrements
by 1. Standard/Non-Standard is not displayed.
[6] Octal to Binary button
Pressing this button will convert a DCS Code of octal number into a
binary number in the text field of the binary notation setting area.
[7] Binary notation setting area
[8] Binary Code (Custom)
Waveforms are generated by a set value in binary notation.
Binary Code is used to add errors to DCS Code.
[9] Binary text field
Input DCS Code by numerical keypad or rotary knob in binary
notation.
The binary DCS Code is displayed in octal notation inside the
parenthesis.
[10] Standard/Non-Standard display
See [4].
[11] Bit button
A bit is reversed when its corresponding button is pressed. When a
bit has an error, the button turns red.
[12] [Parity], [Fixed], [DCS Code] field button
When the corresponding field has an error, pressing the button can
correct it.
[13] Compare error to
Octal Code: Calculates errors of the binary text field based on
the Octal Code value.
DCS Code field of Binary Code:
Calculates errors of the binary text field based on
the DCS Code value.