Anritsu MX269018A - Appendix A Error Message

A-1
Appendix A
Appendix A
Error Message
Table A-1 Error Messages
Message Description
Out of range.
−
Prohibited when Mode is TX.
−
Prohibited when Mode is RX.
−
Invalid Operation for running decode monitor.
−
Valid only when Mode is TX and modulation is
FM.
−
USB Audio device doesn't exist.
−
AF1 user wave-file format is abnormal
−
Valid only when measurement is complete
state
−
Insufficient data.
The number of command arguments is wrong. Only
the remote control is supported.
Invalid numeric data.
Invalid data was specified for numeric data. Only the
remote control is supported .
Invalid string data.
Invalid data was specified for string data. Only the
remote control is supported.
Not available when AF Level is invalid value.
−
Only available while replaying.
−
Shortage of data samples in IQ data file.
Analysis cannot be performed because the number of
data samples of the IQ data file is less than the
minimum number of data samples required for
analysis.
Unsupported SpanFrequency.
−
Unsupported SamplingClock.
−
Not available if not re-capture after changing
common parameter
The operation is invalid if re-capture is not
performed after common parameters change.
Not available during measurement.
−
Invalid character
−
Not available when Frequency Graph or Time
Graph is Off.
The setting is not available when Frequency Domain
or Time Domain is Off.
Not available when Deflection View is Off.
−
Valid only when Signal Frequency is Manual.
−
Not available when AF Frequency Reference is
Off.
−
Valid only when the Audio Analyzer option is
installed.
Invalid if the MS2830A-018/118 Audio Analyzer is
not installed.
Not available when AMA is being operated
with other applications.
−