Anritsu MX269018A - Page 170

Appendix A Error Message
A-2
Table A-1 Error Messages (Cont’d)
Message Description
Valid only when Audio Generator's Waveform is
Tones.
−
Valid only when Audio Generator's Waveform is
DCS.
−
Valid only when Audio Generator's Waveform is
Tones or DCS.
−
Valid only when Audio Generator's Waveform is
Noise.
−
Valid only when Audio Generator's Waveform is
DTMF.
−
Entered value cannot exceed "xxx".
A value exceeding “xxx” cannot be set for Bottom
Level.
Entered value cannot be less than "xxx".
A value less than “xxx” cannot be set for Top Level.
Entered value cannot exceed "xxx".
A value exceeding “xxx” cannot be set for Start
Frequency.
Entered value cannot be less than "xxx".
A value less than “xxx” cannot be set for Stop
Frequency.
Valid only when Time Domain is On.
−
Valid only when Frequency Domain is On.
−
Valid only when Scale Mode is Fixed.
Fixed Range can be set only when Scale Mode is
Fixed.
Valid only when Scale Mode is Auto.
Minimum Range can be set only when Scale Mode
is Auto.
Valid only when Unit is %.
−
Valid only when Unit is dB.
−
Valid only when Unit is Hz.
−
Valid only when Meter is On.
−
Valid only when Mode is TX and modulation is
AM.
−
Valid only when Mode is TX and modulation is
PM.
−
Valid only when X-AXIS is Log.
−
Valid only when X-AXIS is Linear.
−
Valid only when Marker Mode is Delta.
−
Valid only when Modulation is not Wide FM.
−
Valid only when AMA is being operated with
other applications.
−