3-6 Saving Measurements Quick Start Guide
3-14 PN: 10580-00301 Rev. D MS20xxB UG
3-6 Saving Measurements
Measurement files can be stored in the following formats:
*.jpg JPEG images, filename.jpg
*.mna Measurements, filename.mna
*.stp Setups, filename.stp
*.s2p S2P (SnP), filename.s2p
*.spa Spectrum Analyzer Measurements, filename.spa
*.csv Text file with Comma Separated Values (CSV), filename.csv
*.txt Text file with tab separated values, filename.txt
*.lim Limit lines, filename.lim
Saving files in .mna format is recommended because it enables you to edit, view, and
analyze traces with Line Sweep Tools. For more information, refer to the Line Sweep Tools
Help file for the instrument and measurement files supported.
Procedure for saving files:
1. Press Shift then File (7).
2. Press Save Measurement.
3. Press Change Save Location and set the current location to be the USB flash drive or
internal memory, and then press Set Location.
4. In vector network analyzer mode, press Change Type (Setup/JPG/…) and select the
desired file type from the Select File Type list box.
5. In spectrum analyzer mode or interference analyzer mode, press one of the 4 soft keys to
specify a file type.
6. Enter the filename by using the keyboard and then press Enter.
Refer to Chapter 4, “File Management” for more details about working with files.
To Next Page
Loading...
Need help?
General
