APRILIA MXV 450 - Page 205

Coolant replacement
•
Place a container of suitable capacity
underneath the sleeve.
•
Release the clamp.
•
Slide off the sleeve.
•
Empty the liquid into the container.
•
Open the radiator cap to facilitate
drainage.
FILLING
•
Refit the sleeve and fasten it with a new clamp.
•
Top-up with coolant.
See also
Top-up
Water pump
CAUTION
IT IS NOT NECESSARY TO REMOVE THE COOLANT PUMP UNLESS THE COOLANT LEVEL IS
EXTREMELY LOW OR WHEN THE COOLANT DOES NOT HAVE ENGINE OIL.
NOTE
PLACE A CLOTH UNDER THE PUMP BEFORE REMOVING ITS COMPONENTS.
•
Undo and remove the four pump cover
fixing screws.
•
Remove the water pump cover and col-
lect the seal gasket.
MXV 450 Cooling system
COOL SYS - 205