do not necessarily need to stop playing a pattern to listen to another. The same applies
to switching from Bank to Bank.
4.5.3 Change Instrument parameters
The three knobs above each of the instrument's pad are the instrument's parameters.
Let's try and change the pitch of the snare drum. While the pattern is playing, place your
cursor over the "Pitch" knob, click on it and while maintaining your click and move your
cursor up and down slowly. This will turn the "Pitch" knob up and down. Listen how the
pitch of the Snare drum is changing. The Digital display window in the center of the main
panel shows the changes applied to the Pitch (number of semitones).
4.5.4 Select an Instrument and change filter and mixer parameters
To select an instrument, for example the snare drum, move your cursor to the dividing
line above the 2
nd
pad from the left called "Snare Drum". The dividing line will be
highlighted to let you know that you entered its selection zone.
Click once. The "Snare drum" pad is now lit as well as the red diode. The instrument
"Snare Drum" is now selected. Alternatively, press the Select Button and an instrument
pad to select it.
Click the Select Button again to exit from the Select mode.
To change the filter and/or the mixer parameters, first select an instrument and simply
click on one of the filter or mixer parameter buttons and while holding your click, then
move your mouse up or down to change the parameter's value. The Digital display
window in the center of the main panel shows you in real time the changes applied to
the selected parameter.
To Next Page
Loading...