Arturia SPARK - Parametric EQ Parameters; Phaser Parameters

ARTURIA – SPARK CREATIVE DRUM MACHINE – USER’S MANUAL
55
A distortion saturates and distorts a sound by increasing the volume of a signal then
clipping the excess. This effect can add strength, high-end and be volume to a sound.
Parametric EQ parameters
1
Change Low gain
2
Change Low frequency
3
Change Middle frequency
4
Change Middle gain
5
Change Middle band frequency width
6
Change High frequency
7
Change High gain
Parametric EQ allows one to boost or reduce the volume of frequency bands. FREQ
selects the frequency and GAIN allows one to remove or add volume to that band. Width
(MID only) determines the width of the middle band around the specified FREQ.
Phaser parameters
1
Change Tempo sync on/off
2
Change Rate on stage 1 and/or stage 2