VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved oved
Is
Page 106 of 308 Page 106 of 308
7.3.4.1 Configuring a Button as Unused 7.3.4.1 Configuring a Button as Unused
Any button that is not in use should be configured as unused, to prevent inadvertent operation. Any button that is not in use should be configured as unused, to prevent inadvertent operation.
!
!
In order to configure microphone button to unused proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select the required input:
[I/P #01 – MIC/LINE 01]
Default value: input 1
Possible inputs: 01 to 04 for VAR4
01 to 12 for VAR12
01 to 20 for VAR20
Note: The input name is shown on the right side of the display. The input name above is the Mic/Line
input 1 default name, however this may have been changed according to each site’s
configuration.
3. The configured Mic/Line type is displayed.
The input type may be changed, as described in Section “7.1 Mic/Line Input Type Configuration”.
4. Press the SELECT key to display the next sub-menu.
5. Move to, and select the Buttons menu item.
[Buttons] Audio Ctrl Name
Note: The ‘Buttons’ menu item is only available for Paging and Zoned Fire Microphones.
6. Move to, and select the Zoning menu item.
PTT [Zoning] Switches Cough
7. Move to, and scroll the button list until the required button is displayed in the left field:
[Button #01] Not-Conf Security
Default value: ‘Button #01’
Button numbers: 01 to 30
To Next Page
Loading...