ASL INTERCOM VAR4 - Packing for Return for Repair

VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved Is
Page 303 of 308
24.6.1 Packing for Return for
Repair
All electronics assemblies must be
properly packed in ESD protective
packing for transport, to prevent
physical and ESD damage. Use of
non-ESD protective packing for return
for repair or service will automatically
invalidate the warranty.
The filler material used for packing for
return for repair must be antistatic or
static dissipative, as this may come
into contact with exposed connectors,
wiring, or PCB assemblies. The use
of non-conductive filler material may
cause damage to the electronic
assemblies reducing their operational
life, or even destroying them, and it
will automatically invalidate the
warranty.
!
!
!
!
Advice on packing the product for return can be
provided by Application Solutions Limited.