VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 96 of 308
sue: 03 complete, approved
7.2.12 Local Fallback Configuration
It is possible to define a local audio input, typically a DVA, to act as a fallback to local microphone inputs.
The fallback audio source is used if the original audio source is unavailable for any reason.
In order to configure the local fallback proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆFall.
2. Move to, and scroll the input name list until the required local microphone input is displayed in the left
field:
[MIC/LINE 01] Not-Conf
Default value: MIC/LINE 01 (local)
Inputs: VAR4: Local inputs: 4 Mic/Line inputs + 4 DVAs + 1 music + Mute
VAR12: Local inputs: 12 Mic/Line inputs + 8 DVAs + 1 music + Mute
Network inputs: 8 Mic/Line inputs + 4 DVAs + 1 music + Mute
VAR20: Local inputs: 20 Mic/Line inputs + 12 DVAs + 1 music + Mute
Network inputs: 8 Mic/Line inputs + 4 DVAs + 1 music + Mute
Note: The input list comprises the names of all Mic/Line inputs, all DVAs, the music input, the mute
input, and the network inputs. The number of inputs varies according to the VAR Router model,
as described above. Not all inputs in the list are relevant for the current configuration. It is
important that the required input name is obtained from the system design documentation.
The input name above is the Mic/Line input 1 default name, however this may have been
changed according to each site’s configuration.
Network inputs are only shown when the VAR Router is set for network operation. They are
identified by the ‘Net-‘ prefix.
3. Move to, and toggle to the required local DVA in the right field:
MIC/LINE 01 [Not-Conf]
Default value: ‘Not-Conf’ (no fallback assigned to selected input)
Fallback inputs: VAR4: 4 Mic/Line inputs + 4 DVAs + 1 music + Mute
VAR12: 12 Mic/Line inputs + 8 DVAs + 1 music+ Mute
VAR20: 20 Mic/Line inputs + 12 DVAs + 1 music+ Mute
Note: The local fallback should be one of the local DVAs.
The fallback input list comprises the names of all Mic/Line inputs, all DVAs, the music input, and
the mute input. The number of inputs varies according to the VAR Router model, as described
above. Not all inputs in the list are relevant for the current configuration. It is important that the
required input name is obtained from the system design documentation.
4. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
To Next Page
Loading...