ASL INTERCOM VAR4 - MIC;Line Inputs 1, 3 and 4 Type Configuration

VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved ed Is
Page 26 of 308 Page 26 of 308
5.1.2.2 Mic/Line Inputs 1, 3 and 4 Type Configuration 5.1.2.2 Mic/Line Inputs 1, 3 and 4 Type Configuration
Mic/Line inputs 1, 3, and 4 should be set to ‘Unused’ in order to exclude the input from routing and audio
monitoring. An ‘Unused’ input can then be normally used for the connection of microphones or other audio
sources.
Mic/Line inputs 1, 3, and 4 should be set to ‘Unused’ in order to exclude the input from routing and audio
monitoring. An ‘Unused’ input can then be normally used for the connection of microphones or other audio
sources.
In order to set the Mic/Line input type to ‘Unused’ proceed as follows. In order to set the Mic/Line input type to ‘Unused’ proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line. 1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select input 1: 2. Scroll the Mic/Line input list and select input 1:
[I/P #01 – MIC/LINE 01] [I/P #01 – MIC/LINE 01]
3. Scroll the possible Mic/Line types until the ‘Unused’ option is displayed: 3. Scroll the possible Mic/Line types until the ‘Unused’ option is displayed:
[Unused] [Unused]
4. Save the changes by pressing the SELECT key. 4. Save the changes by pressing the SELECT key.
5. Repeat steps 1 to 4 for inputs 3 and 4, if required. 5. Repeat steps 1 to 4 for inputs 3 and 4, if required.
Reference to Configuration Tool Reference to Configuration Tool
5.1.2.2