ASL INTERCOM VAR4 - Mains Derived DC Supply Feeding Slots 3 and 4; Auxiliary DC Supply Voltage

VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 272 of 308
2. Scroll and select a mainframe from the list:
The mainframe description will be shown on the right side, if defined.
3. Move to, and select the Measured menu item.
sue: 03 complete, approved
18.4.6 Mains Derived DC Supply Feeding Slots 3 and 4
The mains derived DC supply voltage feeding slots 3 and 4 in a mainframe can be displayed, as described in
the following steps.
1. Select TestsÆStatus.
2. Scroll and select a mainframe from the list:
[Frame#nn - ]
Mainframe: 01 to 63
Note: Only configured mainframes are displayed.
The mainframe description will be shown on the right side, if defined.
3. Move to, and select the Measured menu item.
DIP = 000000 [Measured] Slot#1
4. Move to, and select the DC2 menu item:
BAT B1 B2 DC1 [DC2] AUX Temp
5. The DC supply voltage is displayed:
[DC Monitor 2 Volts= 20.4]
6. Return to the parent menu by pressing the SELECT key, or the BACK key.
18.4.7 Auxiliary DC Supply Voltage
The Auxiliary DC supply voltage in a mainframe can be displayed, as described in the following steps.
1. Select TestsÆStatus.
[Frame#nn - ]
Mainframe: 01 to 63
Note: Only configured mainframes are displayed.
DIP = 000000 [Measured] Slot#1
4. Move to, and select the AUX menu item:
BAT B1 B2 DC1 DC2 [AUX] Temp
5. The Auxiliary DC supply voltage is displayed:
[AUX Supply Volts= 15.7]
6. Return to the parent menu by pressing the SELECT key, or the BACK key.