VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 299 of 308
3
sue: 03 complete, approved
23.1.3 Default Settings
Table 2 VAR Router Default Settings
Setting Default Value
VAR Route
VAR Router access code ‘1999’ User 1
‘0999’ User 2
VAR Router ID 01
VAR Router name Blank
Date / Time Current date / time
Report over-temperature No
Maximum temperature 70°C
RS232 port modes CTS disabled / Direct Connect
Fault sounder during emergency Enabled
Remote fault output 1 Active Sounder
Remote fault output 2 Active Indicator
Host Protocol
Host protocol routing timeout Enabled / 1min
Host protocol fault timeout Disabled / 60s
Host protocol ‘make route’ message Chime supported
Password control Menu and Host / No warning message
Operation Mode
Stand-alone Number of Network Channels = 0
Input
Input Type (Mic/Line) Unused
Inputs 1 an 2 = Fire Microphone
Input Gain
−14dB (microphones)
−20dB (DVAs)
−25dB (music A and B)
Input name MIC/LINE nn
nn=input number
Input ANS Enabled / Not ANS Tolerant
Class High Emergency (fire mic. and LDVA #1)
Low Emergency (LDVA #2)
Non Emergency (other audio sources)
Priority Fire microphone on input 1: 1
Fire microphone on input 2: 2
Other microphones: 7
LDVA: 3
SDVA: 5
Background music: 19
Output gain (relative gain) 0dB
EQ 0dB all bands / HPF=On
Fade 00
Input sensitivity Line
Input surveillance On
Input surveillance sensitivity
−40dB
Input Phantom power Off
Chime type Off
Chime level
−12dB
To Next Page
Loading...