ASL INTERCOM VAR4 - MIC;Line Input Configuration as Network Channel

VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved ed Is
Page 28 of 308 Page 28 of 308
Reference to Configuration Tool Reference to Configuration Tool
5.1.3.1
5.1.3.2 Mic/Line Input Configuration as Network Channel
Check that the corresponding Mic/Line inputs are configured as Network Channels according to the number
of channels set in the previous section. The following table describes the Mic/Line input allocation for
network operation.
N
o
of Network Channels Mic/Line
1 1
2 1 and 3
3 1, 3, and 4
In order to configure Mic/Line inputs as Network Channels proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select the required input:
[I/P #01 – MIC/LINE 01]
3. Scroll the possible Mic/Line types until the Network Channel option is displayed:
[Network Channel]
4. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
5. Repeat steps 1 to 4 for the required Mic/Line inputs.
Note: If reducing the number of network channels from a network configuration with more channels,
then the Mic/Line inputs which are no longer used as Network Channel should have their type
set to ‘Unused’, as described in Section “5.1.2.2 Mic/Line Inputs 1, 3 and 4 Type Configuration”.