VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 178 of 308
sue: 03 complete, approved
12.6 Name Configuration
The name of any VAR Router output may be edited to reflect the actual use of the output, e.g. zone number,
or description, as described in the following steps. This is for reference only, and it is shown in output related
menu options.
The most useful scheme is probably to have both the zone number and a code for its description in the zone
name. As there are only twelve characters available then some thought may be needed to come up with a
good scheme, e.g. ‘Z1 T.OFFICE’, ‘Z212 PLAT1, ‘Z23 ARENA’, ‘Z7 LIFT’, etc.
L
A non-blank name should be assigned to the output. The system uses the output name as the
only identifier in some functions, so having a blank name can make the identification difficult.
In order to configure an output name proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆOutputs.
2. From V4.1.0470 or later, move to, and select the Configuration menu item.
[Configuration] Induction Loop
3. Scroll the output list and select the required output:
[O/P #1 - OUTPUT 01]
Default value: output 1
Outputs: 4 outputs for VAR4
12 outputs for VAR12
20 outputs for VAR20
Note: The output name is shown on the right side of the display. The output name above is the
output 1 default name, however this may have been changed according to each site’s
configuration.
Outputs 3, 4, 11, 12, 19, and 20 may have been configured as induction loop output, in which
case, please refer to Section “13 Induction Loop Configuration”.
4. Move to, and select the Name menu item.
Level EQ ANS Surv Override [Name]
5. Edit the output name as required using the arrow keys or the rotary encoder.
[OUTPUT nn ]
Default name: ‘OUTPUT nn’, where nn is the output number
Possible value: alphanumeric string of up to 12 characters
Note: The DEFAULT key may be used to clear the entire text string to all blank, for speedier input.
6. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
To Next Page
Loading...