VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 32 of 308
sue: 03 complete, approved
5.1.3.6 Network Channel Pre-announcement Chime Configuration
The chimes of the network audio sources are set at the Audio Control Unit, so ensure that the chime is
disabled at the local VAR Router.
In order to disable the chime proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select the Network Channel input:
[I/P #01 – MIC/LINE 01]
Default value: input 1
Possible inputs: 01, 03, and 04 can be programmed as Network Channel.
Note: The input name is shown on the right side of the display. The input name above is the Mic/Line
input 1 default name, however this may have been changed according to each site’s
configuration.
3. The configured Mic/Line type is displayed.
[Network Channel]
4. Press the SELECT key to display the next sub-menu.
5. Move to, and select the Audio menu item.
[Audio] Name
6. Move to, and select the Chime menu item.
Surv EQ Fade [Chime] Gain
7. Move to, and scroll until the ‘Off’ option is displayed in the left field:
[Type=Off] LEVEL(dB)-12
8. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
To Next Page
Loading...