ASL INTERCOM VAR4 - Test Tone Input Priority Set-Up

VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved oved Is
Page 165 of 308 Page 165 of 308
11.3 Test Tone Input Priority Set-up 11.3 Test Tone Input Priority Set-up
Setting a priority lower than any other audio source enables the Test Tone to be indefinitely routed without
preventing microphone, and DVA message inputs from overriding it.
Setting a priority lower than any other audio source enables the Test Tone to be indefinitely routed without
preventing microphone, and DVA message inputs from overriding it.
In order to allocate the priority to the Test Tone input proceed as follows. In order to allocate the priority to the Test Tone input proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMiscÆTest Tone. 1. Select ConfigurationÆSystemÆRouterÆInputsÆMiscÆTest Tone.
2. Move to, and select the Pri menu item: 2. Move to, and select the Pri menu item:
Type = Speech Noise [Pri] Gain Type = Speech Noise [Pri] Gain
3. Move to, and scroll the output list until the required output is displayed in the left field: 3. Move to, and scroll the output list until the required output is displayed in the left field:
[OUTPUT 01] Priority-18 [OUTPUT 01] Priority-18
Default value: output 1 name Default value: output 1 name
Outputs: 4 output for VAR4 Outputs: 4 output for VAR4
12 output for VAR12 12 output for VAR12
20 output for VAR20 20 output for VAR20
Note: The output given above is the output 1 default name, however this may have been changed
according to each site’s configuration.
Note: The output given above is the output 1 default name, however this may have been changed
according to each site’s configuration.
4. Move to, and scroll the Test Tone input priority list until the priority to be applied is displayed in the right
field:
4. Move to, and scroll the Test Tone input priority list until the priority to be applied is displayed in the right
field:
OUTPUT 01 [Priority-18] OUTPUT 01 [Priority-18]
Default value: ‘18’ Default value: ‘18’
Possible values: 00 to 19 (00 is the highest priority) Possible values: 00 to 19 (00 is the highest priority)
The Test Tone input should have a lower priority than any DVA messages, and microphone
audio sources. This is to ensure that these audio sources can override the test tone, and
broadcast to the required outputs.
The Test Tone input should have a lower priority than any DVA messages, and microphone
audio sources. This is to ensure that these audio sources can override the test tone, and
broadcast to the required outputs.
!
!
5. Repeat steps 2 to 4 to assign the priority to each output.
8. When all outputs have had their correct priority assigned, save the changes by pressing the SELECT
key, or cancel by pressing the BACK key.