VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 135 of 308
sue: 03 complete, approved
7.4 Single Button Microphone Specific Configuration
7.4.1 PTT Button Zone Selection Configuration
The PTT button of a Single Button Microphone may be configured to broadcast a single output, or a group of
outputs. Pressing the PTT button will then cause the microphone audio to be routed to the programmed zone
selection.
In order to program the zone selection for a PTT button proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select the required input:
[I/P #01 – MIC/LINE 01]
Default value: input 1
Possible inputs: 01 to 04 for VAR4
01 to 12 for VAR12
01 to 20 for VAR20
Note: The input name is shown on the right side of the display. The input name above is the Mic/Line
input 1 default name, however this may have been changed according to each site’s
configuration.
3. The configured Mic/Line type is displayed.
The input type may be changed, as described in Section “7.1 Mic/Line Input Type Configuration”.
4. Press the SELECT key to display the next sub-menu.
5. Move to, and select the PTT menu item:
[PTT] Audio Ctrl Name
Note: The ‘PTT’ menu item is only available for Single Button Microphones.
6. Move to, and select the PTT Zones menu item:
[PTT Zones] Cough
7. Move to, and scroll the output list until the required output is displayed in the left field:
[OUTPUT 01] Not Selected
Default value: output 1 name
Outputs: 4 output for VAR4
12 output for VAR12
20 output for VAR20
Note: The output given above is the output 1 default name, however this may have been changed
according to each site’s configuration.
To Next Page
Loading...