ASL INTERCOM VAR4 - Clearing the Zone Selection Associated with a Routing Contact

VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 211 of 308
sue: 03 complete, approved
14.2.7 Clearing the Zone Selection Associated with a Routing Contact
When re-configuring the route associated to a ‘Routing’ contact, the user has the option to clear down the
route associated with a ‘Routing’ contact at once, as described in the following steps.
1. Select ConfigurationÆSystemÆRouterÆControlÆContacts.
2. Move to, and scroll the contact list until the required contact is displayed in the left field:
[Contact#nn] Routing Not-Surv
Default value: ‘Contact#01’
Contact numbers: 01 to 22 for VAR4
01 to 42 for VAR12
01 to 62 for VAR20
Where contacts: 00 to 10 are analogue
11 to 62 are opto-isolated
3. Press the SELECT key to display the routing configuration menu.
4. Move to, and select the Clear-all menu item to clear any route associated with the contact or cancel by
pressing the BACK key.
Zoning Control [Clear-all]