ASL INTERCOM VAR4 - Setting the VAR Router to Stand-Alone Operation; Network Channel Configuration

VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved ed Is
Page 25 of 308 Page 25 of 308
5.1.2 Setting the VAR Router to Stand-alone Operation 5.1.2 Setting the VAR Router to Stand-alone Operation
In order to change the VAR Router from network mode settings to stand-alone mode, please follow the
instructions.
In order to change the VAR Router from network mode settings to stand-alone mode, please follow the
instructions.
5.1.2.1 Network Channel Configuration 5.1.2.1 Network Channel Configuration
The number of network channels should be set to zero, as described in the following steps. The number of network channels should be set to zero, as described in the following steps.
1. Select ConfigurationÆSystemÆNetÆChannels. 1. Select ConfigurationÆSystemÆNetÆChannels.
2. The number of network channels is displayed: 2. The number of network channels is displayed:
[Network Channel=3] [Network Channel=3]
3. Scroll the network channel field until ‘0’ is displayed. 3. Scroll the network channel field until ‘0’ is displayed.
[Network Channel=0] [Network Channel=0]
4. Save the changes by pressing the SELECT key. 4. Save the changes by pressing the SELECT key.
Reference to Configuration Tool Reference to Configuration Tool
5.1.2.1