ASL INTERCOM VAR4 - Clearing the Route Associated with a DVA Routing Button

VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 129 of 308
sue: 03 complete, approved
7.3.4.3.7 Clearing the Route Associated with a DVA Routing Button
When re-configuring the route associated to a ‘DVA Routing’ button, the user has the option to clear down
the route associated with a ‘DVA Routing’ button at once, as described in the following steps.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select the required input:
[I/P #01 – MIC/LINE 01]
Default value: input 1
Possible inputs: 01 to 04 for VAR4
01 to 12 for VAR12
01 to 20 for VAR20
Note: The input name is shown on the right side of the display. The input name above is the Mic/Line
input 1 default name, however this may have been changed according to each site’s
configuration.
3. The configured Mic/Line type is displayed.
The input type may be changed, as described in Section “7.1 Mic/Line Input Type Configuration”.
4. Press the SELECT key to display the next sub-menu.
5. Move to, and select the Buttons menu item.
[Buttons] Audio Ctrl Name
Note: The ‘Buttons’ menu item is only available for Paging and Zoned Fire Microphones.
6. Move to, and select the Zoning menu item.
PTT [Zoning] Switches Cough
7. Move to, and scroll the button list until the required button is displayed in the left field:
[Button #01] Not-Conf Security
Default value: ‘Button #01’
Button numbers: 01 to 30
8. Press the SELECT key to display the next sub-menu.
9. Move to, and select the Clear-all menu item to clear any route associated with the button or cancel by
pressing the BACK key.
Zoning Control [Clear-all]