VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 253 of 308
sue: 03 complete, approved
16.3.2.7 Clearing the Zone Selection Associated with a Routing Digital Input (Contact)
When re-configuring the route associated to a ‘Routing’ contact, the user has the option to clear down the
route associated with a ‘Routing’ contact at once, as described in the following steps.
1. Select ConfigurationÆSystemÆRouterÆControlÆRemote.
2. Move to scroll the Remote I/O unit list until the required unit is displayed:
[Remote I/O unit=n] Not Configured
Default value: ‘Remote I/O unit=1’
Possible I/O units: 1 to 3 for VAR4
1 to 6 for VAR12
1 to 9 for VAR20
3. Move to, and select the Digital In menu item.
Analogue [Digital In] Digital Out
4. Move to, and scroll the contact list until the required contact is displayed in the left field:
[Contact#nn] Routing Not-Surv
Default value: ‘Contact#01’
Contact numbers: 01 to 12
5. Press the SELECT key to display the routing configuration menu.
6. Select the Clear-all menu item to clear any route associated with the contact or cancel by pressing the
BACK key.
Zoning Control [Clear-all]
To Next Page
Loading...