VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 109 of 308
sue: 03 complete, approved
7.3.4.2 Configuring a Button for Microphone Routing (Zone Selection)
The Microphone Routing button function is for zone selection, i.e. when pressed it selects a specified output
or group of outputs to which the microphone audio is to be routed when PTT button subsequently is pressed.
If a ‘listen-in’ button or key-switch has been configured, and it is activated after pressing a zone selection
button, then the selected output or group of outputs will be routed to the VAR Router’s Aux Output. Refer to
Section “7.3.3 Listen-in Configuration” for further details.
Re-pressing a button will deselect it.
In order to configure a microphone button for zone selection proceed as follows.
1. Select ConfigurationÆSystemÆRouterÆInputsÆMic/Line.
2. Scroll the Mic/Line input list and select the required input:
[I/P #01 – MIC/LINE 01]
Default value: input 1
Possible inputs: 01 to 04 for VAR4
01 to 12 for VAR12
01 to 20 for VAR20
Note: The input name is shown on the right side of the display. The input name above is the Mic/Line
input 1 default name, however this may have been changed according to each site’s
configuration.
3. The configured Mic/Line type is displayed.
The input type may be changed, as described in Section “7.1 Mic/Line Input Type Configuration”.
4. Press the SELECT key to display the next sub-menu.
5. Move to, and select the Buttons menu item.
[Buttons] Audio Ctrl Name
Note: The ‘Buttons’ menu item is only available for Paging and Zoned Fire Microphones.
6. Move to, and select the Zoning menu item.
PTT [Zoning] Switches Cough
7. Move to, and scroll the button list until the required button is displayed in the left field:
[Button #01] Not-Conf Security
Default value: ‘Button #01’
Button numbers: 01 to 30
To Next Page
Loading...