VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 113 of 308
sue: 03 complete, approved
3. The configured Mic/Line type is displayed.
The input type may be changed, as described in Section “7.1 Mic/Line Input Type Configuration”.
4. Press the SELECT key to display the next sub-menu.
5. Move to, and select the Buttons menu item.
[Buttons] Audio Ctrl Name
Note: The ‘Buttons’ menu item is only available for Paging and Zoned Fire Microphones.
6. Move to, and select the Zoning menu item.
PTT [Zoning] Switches Cough
7. Move to, and scroll the button list until the required button is displayed in the left field:
[Button #01] Not-Conf Security
Default value: ‘Button #01’
Button numbers: 01 to 30
8. Move to, and scroll the option list until the ‘DVA Routing’ option is displayed in the middle field:
Button #01 [DVA Routing] Security
Other options available:
• [Not-Conf]
Button is not used.
See Section “7.3.4.1 Configuring a Button as Unused”.
• [MIC Routing]
Configure the selected button for zone selection.
See Section “7.3.4.2 Configuring a Button for Microphone Routing (Zone Selection)”.
• [AllCall]
Configure the selected button as ‘All-Call’ button.
See Section “7.3.4.4 Configuring a Button as an All-Call Button”.
• [{Route Reset}]
The selected button was specified to act as ‘reset’ button of a DVA Routing button configured to
trigger a latched route in the Latching menu. It is not configurable from this sub-menu.
See Section “7.3.4.3.3 Configuring a DVA Routing Button for Latching Mode”.
Note: ‘Route Reset’ is only displayed for Paging or Zoned Fire Microphones that are connected
to VAR Router’s Mic/Line inputs 1 or 2.
Default value: ‘Not-Conf’
9. Save the changes by pressing the SELECT key and proceed with the remaining configuration in the
following sections. Or cancel by pressing the BACK key.
To Next Page
Loading...