VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 131 of 308
sue: 03 complete, approved
8. Move to, and scroll the option list until the ‘AllCall’ option is displayed in the middle field:
Button #01 [AllCall] Security
Other options available:
• [Not-Conf]
Button is not used.
See Section “7.3.4.1 Configuring a Button as Unused”.
• [MIC Routing]
Configure the selected button for zone selection (routing).
See Section “7.3.4.2 Configuring a Button for Microphone Routing (Zone Selection)”.
• [DVA Routing]
Configure the selected button for complex routing.
See Section “7.3.4.3 Configuring a Button for DVA Routing”.
Note: ‘DVA Routing’ is only available for Paging or Zoned Fire Microphones that are connected
to VAR Router’s Mic/Line inputs 1 or 2.
• [{Route Reset}]
The selected button was specified to act as ‘reset’ button of a DVA Routing button configured to
trigger a latched route in the Latching menu. It is not configurable from this sub-menu.
See Section “7.3.4.3.3 Configuring a DVA Routing Button for Latching Mode”.
Note: ‘Route Reset’ is only displayed for Paging or Zoned Fire Microphones that are connected
to VAR Router’s Mic/Line inputs 1 or 2.
Default value: ‘Not-Conf’
9. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
To Next Page
Loading...