VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved oved
Is
Page 197 of 308 Page 197 of 308
• Not-Surv • Not-Surv
Disables the analogue contact monitoring. Disables the analogue contact monitoring.
• Surv • Surv
Enables the analogue contact monitoring. Enables the analogue contact monitoring.
4. Move to, and scroll the operation options until the ‘Routing’ option is displayed: 4. Move to, and scroll the operation options until the ‘Routing’ option is displayed:
Contact#01 [Routing] Not-Surv Contact#01 [Routing] Not-Surv
Other options available: Other options available:
• Not-Conf • Not-Conf
The contact is not connected. The contact is not connected.
See Section “14.1 Configuring a Contact as Unused”. See Section “14.1 Configuring a Contact as Unused”.
• External Fault • External Fault
The contact is used as an external fault input. The contact is used as an external fault input.
See Section “14.3 Configuring a Contact as an External Alarm”. See Section “14.3 Configuring a Contact as an External Alarm”.
• Rem Fault Accept • Rem Fault Accept
The contact is used as the ‘Accept’ for a remote fault panel acting as a local fault accept button
affecting only the remote indication.
The contact is used as the ‘Accept’ for a remote fault panel acting as a local fault accept button
affecting only the remote indication.
See Section “14.4 Configuring a Contact as Remote Fault Accept”. See Section “14.4 Configuring a Contact as Remote Fault Accept”.
• Reset Contact • Reset Contact
This contact was specified to act as the ‘reset’ contact of a contact configured to trigger a latched
latent route. It is not configurable from this sub-menu.
This contact was specified to act as the ‘reset’ contact of a contact configured to trigger a latched
latent route. It is not configurable from this sub-menu.
See Section “14.2.3 Configuring a Routing Contact for Latching Mode”. See Section “14.2.3 Configuring a Routing Contact for Latching Mode”.
• Music Select • Music Select
This contact was selected as a control to switch between Music A and Music B phono inputs. It is
not configurable from this sub-menu.
This contact was selected as a control to switch between Music A and Music B phono inputs. It is
not configurable from this sub-menu.
See Section “9.2 Contact Music Selector Configuration”. See Section “9.2 Contact Music Selector Configuration”.
5. Save the changes by pressing the SELECT key and proceed with the remaining configuration in the
following sections. Or cancel by pressing the BACK key.
5. Save the changes by pressing the SELECT key and proceed with the remaining configuration in the
following sections. Or cancel by pressing the BACK key.
Make sure the selected contact is a Routing contact. Once the SELECT key is pressed, the
contact will be configured for routing and the previous configuration will be lost.
Make sure the selected contact is a Routing contact. Once the SELECT key is pressed, the
contact will be configured for routing and the previous configuration will be lost.
!
!
To Next Page
Loading...