VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved oved
Is
Page 204 of 308 Page 204 of 308
• [Mode=Play Once] • [Mode=Play Once]
Configures the contact for ‘Play Once’ mode. Configures the contact for ‘Play Once’ mode.
When this mode is selected, the associated DVAs are played once only. When this mode is selected, the associated DVAs are played once only.
See Section “14.2.4 Configuring a Routing Contact for Play Once Mode”. See Section “14.2.4 Configuring a Routing Contact for Play Once Mode”.
Default value: ‘Mode=Not Latched’ Default value: ‘Mode=Not Latched’
7. Move to, and scroll the reset contact list until the required contact to provide the reset is displayed in the
right field:
7. Move to, and scroll the reset contact list until the required contact to provide the reset is displayed in the
right field:
Mode= Latched [ResetContact -1] Mode= Latched [ResetContact -1]
Default value: n.a. Default value: n.a.
Reset contact: 1 to 22 for VAR4 Reset contact: 1 to 22 for VAR4
01 to 42 for VAR12 01 to 42 for VAR12
01 to 62 for VAR20 01 to 62 for VAR20
Note: A group of Routing contacts may share a single reset contact, or each Routing contact may
have its own dedicated reset contact.
Note: A group of Routing contacts may share a single reset contact, or each Routing contact may
have its own dedicated reset contact.
8. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key. 8. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
Reference to Configuration Tool Reference to Configuration Tool
14.2.3
To Next Page
Loading...