VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved
Is
Page 224 of 308
7. Move to, and toggle to the required selection option in the right field:
The output is not associated with the Programme Selector.
5. Move to, and select the Selector menu item:
UNUSED [Selector] Volume Fault ANS
Other options available:
• Unused
Select this option if the analogue input is not connected.
See Section “16.2.1 Configuring an Analogue Input as Unused”.
• Volume
Assign the selected analogue input as Volume Control.
See Section “16.2.3 Configuring an Analogue Input as Volume Control”.
• Fault
Assign the selected analogue input as Fault Input.
See Section “16.2.4 Configuring an Analogue Input as Fault Input”.
• ANS
Assign the selected analogue input as Ambient Noise Sensor (ANS).
See Section “16.2.5 Configuring an Analogue Input as Ambient Noise Sensor (ANS)”.
6. Move to, and scroll the output list until the required output is displayed in the left field:
[OUTPUT 01] Not Selected
Default values: output 1 name
Outputs: 4 output for VAR4
12 output for VAR12
20 output for VAR20
Note: The output given above is the output 1 default name, however this may have been changed
according to each site’s configuration.
OUTPUT 01 [Not Selected]
• [Not Selected]
• [Selected]
The output is associated with the Programme Selector. The input assigned to a Programme
Selector position will be routed to this output when the position is selected.
Default value: ‘Not-Selected’
There should be only one Programme Selector associated with an output or group of
outputs. Associating an output with more than one Program Selector would cause
unpredictable results.
!
!
8. Repeat steps 6 to 7 to configure each output.
9. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
10. Pressing the SELECT key will display a sub-menu which allows the user to assign an input to each
Programme Selector position.
To Next Page
Loading...