ASL INTERCOM VAR4 - Page 228

VAR4 / VAR12 / VAR20 - Operation Manual
Is
Page 228 of 308
sue: 03 complete, approved
5. Move to, and select the Volume menu item:
UNUSED Selector [Volume] Fault ANS
Other options available:
• Unused
Select this option if the analogue input is not connected.
See Section “16.2.1 Configuring an Analogue Input as Unused”.
• Selector
Assign the selected analogue input as Programme Selector.
See Section “16.2.2 Configuring an Analogue Input as Programme Selector”.
• Fault
Assign the selected analogue input as Fault Input.
See Section “16.2.4 Configuring an Analogue Input as Fault Input”.
• ANS
Assign the selected analogue input as Ambient Noise Sensor (ANS).
See Section “16.2.5 Configuring an Analogue Input as Ambient Noise Sensor (ANS)”.
6. Move to, and scroll the output list until the required output is displayed in the left field:
[OUTPUT 01] Not Selected
Default values: output 1 name
Outputs: 4 output for VAR4
12 output for VAR12
20 output for VAR20
Note: The output given above is the output 1 default name, however this may have been changed
according to each site’s configuration.
7. Move to, and toggle to the required selection option in the right field:
OUTPUT 01 [Not Selected]
• [Not Selected]
The output is not controlled by the Volume Control.
• [Selected]
The output is controlled by the Volume Control. Any input configured to the Volume Control will
have the volume affected when routed to this output.
Default value: ‘Not-Selected’
8. Repeat steps 6 to 7 to configure each output.
9. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
10. Pressing the SELECT key will display a sub-menu which allows the user to select the inputs controlled
by the Volume Control.