VAR4 / VAR12 / VAR20 - Operation Manual
sue: 03 complete, approved oved
Is
Page 242 of 308 Page 242 of 308
Default value: ‘Not-Conf’ Default value: ‘Not-Conf’
Inputs: VAR4: Local inputs: 4 Mic/Line inputs + 4 DVAs + 1 music + Mute + Test Tone Inputs: VAR4: Local inputs: 4 Mic/Line inputs + 4 DVAs + 1 music + Mute + Test Tone
VAR12: Local inputs: 12 Mic/Line inputs + 8 DVAs + 1 music + Mute + Test Tone VAR12: Local inputs: 12 Mic/Line inputs + 8 DVAs + 1 music + Mute + Test Tone
Network inputs: 8 Mic/Line inputs + 4 DVAs + 1 music + Mute + Test Tone Network inputs: 8 Mic/Line inputs + 4 DVAs + 1 music + Mute + Test Tone
VAR20: Local inputs: 20 Mic/Line inputs + 12 DVAs + 1 music + Mute + Test Tone VAR20: Local inputs: 20 Mic/Line inputs + 12 DVAs + 1 music + Mute + Test Tone
Network inputs: 8 Mic/Line inputs + 4 DVAs + 1 music + Mute + Test Tone Network inputs: 8 Mic/Line inputs + 4 DVAs + 1 music + Mute + Test Tone
Note: The input list comprises the names of all Mic/Line inputs, all DVAs, the music input, the mute
input, and the network inputs. The number of inputs varies according to the VAR Router model,
as described above. Not all inputs in the list are relevant for the current configuration. It is
important that the required input name is obtained from the system design documentation.
Note: The input list comprises the names of all Mic/Line inputs, all DVAs, the music input, the mute
input, and the network inputs. The number of inputs varies according to the VAR Router model,
as described above. Not all inputs in the list are relevant for the current configuration. It is
important that the required input name is obtained from the system design documentation.
The input name above is the Mic/Line input 1 default name, however this may have been
changed according to each site’s configuration.
The input name above is the Mic/Line input 1 default name, however this may have been
changed according to each site’s configuration.
Network inputs are only shown when the VAR Router is set for network operation. They are
identified by the ‘Net-‘ prefix.
Network inputs are only shown when the VAR Router is set for network operation. They are
identified by the ‘Net-‘ prefix.
Test Tone is only available from V.4.0.0464. Test Tone is only available from V.4.0.0464.
9. Repeat steps 7 to 8 to configure each output. 9. Repeat steps 7 to 8 to configure each output.
10. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key. 10. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
Reference to Configuration Tool Reference to Configuration Tool
16.3.2.1
DIGITAL INPUT
To Next Page
Loading...